Car battery tester, generator 12V. - Macon Whoopee
Orders by phone Mon-Fri, from 10:00 to 18:00
The tester of a car battery, generator 12 V can be used both by a professional auto repairman at a service station and by a car enthusiast at home. The tester allows you to quickly check the battery voltage of the car ... Read more ...
New mail - from 40 UAH.
Ukrposhta - 25 UAH
To the Privatbank card
Cash on delivery (New Mail)
The tester of a car battery, generator 12 V can be used both by a professional auto repairman at a service station and by a car enthusiast at home. The tester allows you to quickly check the voltage of the car battery, check the operation of the generator, and analyze the starting ability of the car.
Before you start using the tester, connect the positive pole of the battery to the red clamp of the device, and the negative pole to the black clamp. The tester has three possible modes of application: in the first, it checks the generator, in the second - the condition of the battery, in the third - the starting capacity of the battery. Accordingly, there are three zones on the control part of the device. The "Alternator State" zone responsible for the generator state is equipped with a red FAULT LED and a green GOOD. The "Battery State" zone that checks the battery status is equ Car battery tester, generator 12V. - Macon Whoopee ipped with a green FULL LED, a yellow MIDDLE and a red LOW. Finally, the "Check before charge" analysis area of the battery's starting capacity has only one green OK LED.
Connect the tester, turn on the engine, turn off the headlights, FM receiver, etc., then turn off the engine. Now turn on the engine again, and after it turn on the headlights, the receiver, etc. During both procedures, the green GOOD LED located on the top of the tester must light up. If the red FAULT LED is on, then this indicates that the generator does not supply voltage at all or supplies it in an insignificant amount. Be sure to check if you have connected the tester correctly. If the device is connected correctly, but the red LED is still on, you need to contact a car workshop.
How to check the battery status:
Connect the positive pole of the battery to the red clip of the tester and the negative pole to the black clip. Turn on the headlights for one to two minutes and then turn them off. Disconnect the tester clamps for ten minutes and reconnect. After that, one of the three LEDs should light up: green FULL - the battery is fully charged, yellow MIDDLE - the battery is half discharged, red LOW - the charge level is low, the battery is less than half charged.
How to analyze the starting ability of a battery:
Fully charge the battery before performing this test. Remove the contact of the ignition coil and only then connect the tester. Insert the ignition key and try to start the engine. The engine will not start and the ignition will be interrupted. If the green OK LED turns on, your battery is in excellent condition. If not everything is in order with the starter, the LED will not light up, despite the fact that the battery is fully charged. Attention! Do not run the engine for more than two to three seconds, otherwise you risk damaging the accelerator.
- tester of car battery, generator 12 V in original packaging;
http://www.maconwhoopee.com/car-battery-tester-generator-12v/
Comments
Post a Comment